CrossRef enabled

PAC Archives

Archive →

Pure Appl. Chem., 2002, Vol. 74, No. 5, pp. 857-867

http://dx.doi.org/10.1351/pac200274050857

MACROMOLECULAR DIVISION

Polyaniline. Preparation of a conducting polymer(IUPAC Technical Report)

J. Stejskal1* and R. G. Gilbert2

1 Institute of Macromolecular Chemistry, Academy of Sciences of the Czech Republic, 162 06 Prague 6, Czech Republic
2 Key Centre for Polymer Colloids ­ F11, University of Sydney, NSW 2006, Australia

Abstract: Eight persons from five institutions in different countries carried out polymerizations of aniline following the same preparation protocol. In a "standard" procedure, aniline hydrochloride was oxidized with ammonium peroxydisulfate in aqueous medium at ambient temperature. The yield of polyaniline was higher than 90 % in all cases. The electrical conductivity of polyaniline hydrochloride thus prepared was 4.4 ± 1.7 S cm-1 (average of 59 samples), measured at room temperature. A product with defined electrical properties could be obtained in various laboratories by following the same synthetic procedure. The influence of reduced reaction temperature and increased acidity of the polymerization medium on polyaniline conductivity were also addressed. The conductivity changes occurring during the storage of polyaniline were monitored. The density of polyaniline hydrochloride was 1.329 g cm-3. The average conductivity of corresponding polyaniline bases was 1.4 x10­8 S cm-1, the density being 1.245 g cm-1. Additional changes in the conductivity take place during storage. Aging is more pronounced in powders than in compressed samples. As far as aging effects are concerned, their assessment is relative. The observed reduction in the conductivity by ~10 % after more than one-year storage is large but, compared with the low conductivity of corresponding polyaniline (PANI) base, such a change is negligible. For most applications, an acceptable level of conductivity may be maintained throughout the expected lifetime.